The ease of this purchase was a good start. The content of this manual was exactly all I needed to retore my Tandberg 64.
All of the mechanical and electrical information is contained in the manual and the quality of the document makes reading the data easy.
The exerience with the resource has made this my prime source for technical data.
Text excerpt from page 159 (click to view)
Cartridge fan (fan #5)
1 2
Remove the back cover (page 126). Remove the J-216 cable connector (callout 1) from the DC controller.
1 2
Figure 103.
Removing the cartridge fan (1 of 2)
3 4 5 6 7 8
Remove tray 1 if it is installed (page 140). Open the right door. Release the strap by pinching and then pushing the two tabs (page 122, callout 1) on the end of the black strap. Remove two silver screws (callout 2) from the cartridge fan. Locate the two arrow-marked tabs (callout 3), and then press the arrow-marked area in the marked direction. Slide the cartridge fan to the right to remove it.
2 3
2
Figure 104.
Removing the cartridge fan (2 of 2)
To reinstall
Slide the tabs into the printer before you snap the fan into place.
C8519-90912
